The brackets are made from high grade steel, bent and powder coated black. The laser cut raw aluminum logo plates and lightweight aluminum clamps make up a great kit that should work for most with the right light bar! NOTE: The new and improved bracket introduces bends at the cage mounting points - these bends equal roughly 1/2 inch of inset or offset compensation. The brackets are reversible, so if an extra half inch either way is necessary just remove the logo plates, swap the brackets around and remount. It is also important to measure your cage at the top to determine what size light bar will fit. In some cases spacers may be required, we recommend picking up washers if only 1 or 2 on either side are needed - Anything more than that, try swapping the brackets around. NOTE: Will not work with cages that have built in gusset plates at the A-Pilar. Gussets will need to be removed or use with aftermarket cage. Confirmed to work with:KC Hilites Flex, C-Series and Gravity 39-40" light barsRigid E-Series, Radiance, curved, SR-Series Pro 40" light barsBaja Designs S8 40" light barVision X XPL 40" light bar Package Contents (2) Brackets (4) Clamps (2) Logo plates Installation hardware
WARNING:This product can impact machine operation. Customer and/or user is responsible for ensuring that this product is compatible with their machine as currently configured, properly installed, and understands any impact this product has or might have on the machine's operation.
⚠California Proposition 65 Warning⚠ WARNING:This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.
